Your furnace is a key part of your home. Without one, you wouldn’t be able to stay warm during cold weather. Yet furnaces can have some problems that are more typical than others.

Let’s review these problems and discuss what they might cost to fix so you know before you contact an HVAC technician. Some of the most common furnace repair issues include:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Won’t Turn On

There are a few reasons why your furnace won’t turn on, so make sure to go through all of them.

  • Is your thermostat set right? Make sure it’s set to “heat,” “auto” and that your preferred temperature is higher than the room’s current temperature. If you use a programmable thermostat, make sure it has fresh batteries.
  • Is the circuit breaker tripped? Your furnace can’t run if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch located on or close to it. Since this switch resembles a light switch, it’s easy to accidentally turn it off. If it was off, it might take your furnace a few minutes to start.
  • Is the air filter clean? A dusty air filter can cause a lot of problems for your furnace. Replace yours if you can’t see light through it.

Estimated Repair Cost

This problem can be complex, so the estimated cost to repair it varies according to what’s wrong.

2. My Furnace Won’t Stay Lit

Your furnace uses a specific sequence when it starts heating your home.

  1. Your thermostat notices the temperature has fallen and tells your furnace to start running.
  2. The draft inducer fan activates to pull in fresh air for combustion.
  3. The gas valve opens for the burners, which are ignited electronically.
  4. The flame sensor signals to your furnace the burners have been ignited.

If something is off during the sequence, your furnace will shut down as a safety precaution.

A couple of possible causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to keep natural gas from getting into your home. The ignition process corrodes flame sensors as time passes. While cleaning during an